ClareControls CH-THSTAT-W Guía de usuario descargar pdf (Pagina 15)

Clare Controls IP Network Camera User Guide 7

Setting the network camera over a WAN

This section explains how to connect the network camera to a WAN with a static IP or a

dynamic IP.

Static IP connection

Apply a static IP from an ISP (Internet Service Provider). With the static IP address, you

can connect the network camera via a router or connect it to a WAN directly.

To connect the network camera via a router:

1. Connect the network camera to the router.

2. Assign the LAN IP address, subnet mask, and gateway.

3. Save the static IP in the router.

4. Set port mapping – for example, 80, 8000, 8200, and the 554 ports. The steps for

port mapping vary based on router. Call the router manufacturer for assistance with

port mapping.

Note: Refer to Appendix 2 for detailed information about port mapping.

5. Visit the network camera through a web browser or the client software.

Figure 4: Accessing the camera though a router with a static IP

Connecting the network camera with static IP directly

You can save the static IP in the camera and connect it directly to the internet without

using a router.

Figure 5: Accessing the camera with static IP directly

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 91 92

Sin comentarios

ClareControls CH-THSTAT-W Guía de usuario Pagina 15